Filter
Top Products
107
Event Configuration
You can select the ‘Syslog’ and ‘SMTP’ events. When selected events occur, the
system will send out the log information. Also, per port log and SMTP events can be
selected. After configuring, Click ‘Apply’.
• System Event selection: 4 selections – Device cold start, Device warm start,
SNMP Authentication Failure, and X-ring topology change. Pull down the selection
menu items to select the events. When selected events occur, the system will issue
the logs.
¾ Device cold start: when the device executes cold start action, the system
will issue a log event.
¾ Device warm start: when the device executes warm start, the system will
issue a log event.
¾ Authentication Failure: when the SNMP authentication fails, the system will
issue a log event.
¾ X-ring topology change: when the X-ring topology has changed, the system
will issue a log event.
• Port Event selection: Pull down the selection menu items to select the Syslog and
SMTP events of each port. It has 3 selections – Link Up, Link Down, and Link UP
& Link Down. Disable means no event is selected.
¾ Link UP: the system will issue a log message when port connection is up
only.
¾ Link Down: the system will issue a log message when port connection is
down only.
¾ Link UP & Link Down: the system will issue a log message when port
connection is up and down.
Figure C.28: Event Configuration
C.1.6 Time (SNTP)
You can configure the SNTP (Simple Network Time Protocol) settings. The SNTP
allows you to synchronize switch clocks in the Internet.
Basic Setting: