Filter
Top Products
47 Chapter3
Figure 3.17: SMTP Configuration
System Event Log - Event Configuration
You can select the system log events and SMTP events. When selected events occur, the system will
send out the log information. Also, per port log and SMTP events can be selected. After configure,
Click
Apply
.
• System event selection: 4 selections – Device cold start, Device warm start, SNMP Authentication
Failure, and X-ring topology change. Mark the checkbox to select the event. When selected events
occur, the system will issue the logs.
¾ Device cold start: when the device executes cold start action, the system will issue a log event.
¾ Device warm start: when the device executes warm start, the system will issue a log event.
¾ Authentication Failure: when the SNMP authentication fails, the system will issue a log event.
¾ X-ring topology change: when the X-ring topology has changed, the system will issue a log
event.
• Port event selection: select the per port events and per port SMTP events. It has 3 selections – Link
Up, Link Down, and Link UP & Link Down. Disable means no event is selected.
¾ Link UP: the system will issue a log message when port connection is up only.
¾ Link Down: the system will issue a log message when port connection is down only.
¾ Link UP & Link Down: the system will issue a log message when port connection is up and
down.