Filter
Top Products
EKI-7758F User Manual 26
After you have logged in to the system, you will see a command prompt. To enter CLI management interface,
type in “enable” command.
Figure 3.4: Command Line Interface
The following table lists the CLI commands and description.
3.1.1 Commands Level
Table 3.1: Command Level
Modes Access Method Prompt Exit Method About This Model
User EXEC
Begin a session with
your switch.
switch>
Enter logout or quit. The user commands available
at
the user level are a subset of
those available at the
privileged level.
Use this mode to
• Perform basic tests.
• Display system information.
Privileged
EXEC
Enter the enable
command while in
user EXEC mode.
switch#
Enter disable to exit. The privileged command is
advance mode
Privileged this mode to
• Display advance function
status
• save configures
Global
configuration
Enter the configure
command while in
privileged EXEC
mode.
switch(config)#
To exit to privileged
EXEC mode, enter
exit or end
Use this mode to configure
parameters that apply to your
switch as a whole.
VLAN database
Enter the vlan
database command
while in privileged
EXEC mode.
switch(vlan)#
To exit to user EXEC
mode, enter
exit.
Use this mode to configure
VLAN-specific parameters.
Interface
configuration
Enter the interface
command (with a
specific interface)
while in global
configuration mode
switch(config-if)#
To exit to global
configuration mode,
enter exit.
To exist to privileged
EXEC mode, or end.
Use this mode to configure
parameters for the switch and
Ethernet ports.