Filter
Top Products
EKI-7758F User Manual 34
sub-oid
[OID]
show snmp P Show SNMP configuration switch#show snmp
no snmp community-strings
[Community]
G
Remove the specified community. switch(config)#no snmp community-strings public
no snmp-server host
[Host-address]
G
Remove the SNMP server host. switch(config)#no snmp-server 192.168.1.50
no snmpv3 user
[User Name]
G
Remove specified user of SNMPv3
agent.
switch(config)#no snmpv3 user Test
no snmpv3 access context-name
[Context Name ]
group
[Group Name ]
security-level
[NoAuthNoPriv|AuthNoPriv|AuthPriv]
match-rule
[Exact|Prifix]
views
[Read View Name] [Write View Name]
[Notify View Name]
G
Remove specified access table of
SNMPv3 agent.
switch(config)#no snmpv3 access context-name
Test group G1 security-level AuthPr
iv match-rule Exact views V1 V1 V1
no snmpv3 mibview view
[View Name]
type
[Excluded|Included]
sub-oid
[OID]
G
Remove specified mibview table of
SNMPV3 agent.
switch(config)#no snmpv3 mibview view V1 type
Excluded sub-oid 1.3.6.1
3.1.12 Port Mirroring Commands Set
Table 3.12: Port Mirroring Commands Set
Netstar Commands Level Description Example
monitor rx
G
Set RX destination port of monitor
function
switch(config)#monitor rx
monitor tx
G
Set TX destination port of monitor
function
switch(config)#monitor tx
show monitor
P
Show port monitor information switch#show monitor
monitor
[RX|TX|Both]
I
Configure source port of monitor
function
switch(config)#interface fastEthernet 2
switch(config-if)#monitor RX
show monitor
I
Show port monitor information switch(config)#interface fastEthernet 2
switch(config-if)#show monitor
no monitor
I
Disable source port of monitor
function
switch(config)#interface fastEthernet 2
switch(config-if)#no monitor
3.1.13 802.1x Commands Set
Table 3.13: 802.1x Commands Set
Netstar Commands Level Description Example
8021x enable
G
Use the 802.1x global
configuration command to enable
802.1x protocols.
switch(config)# 8021x enable
8021x system radiousip
[IP address]
G
Use the 802.1x system radious IP
global configuration command to
change the radious server IP.
switch(config)# 8021x system radiousip 192.168.1.1
8021x system serverport
[port ID]
G
Use the 802.1x system server port
global configuration command to
switch(config)# 8021x system serverport 1815