Filter
Top Products
EKI-7758F User Manual 54
3.2.2 Port
Port Statistics
The following information provides the current port statistic information.
• Port: The port number.
•
Type:
Displays the current speed of connection to the port.
• Link: The status of linking—‘Up’ or ‘Down’.
• State: It’s set by Port Control. When the state is disabled, the port will not transmit or receive any
packet.
• Tx Good Packet: The counts of transmitting good packets via this port.
• Tx Bad Packet: The counts of transmitting bad packets (including undersize [less than 64 octets],
oversize, CRC Align errors, fragments and jabbers packets) via this port.
• Rx Good Packet: The counts of receiving good packets via this port.
• Rx Bad Packet: The counts of receiving good packets (including undersize [less than 64 octets],
oversize, CRC error, fragments and jabbers) via this port.
• Tx Abort Packet: The aborted packet while transmitting.
• Packet Collision: The counts of collision packet.
• Packet Dropped: The counts of dropped packet.
• Rx Bcast Packet: The counts of broadcast packet.
• Rx Mcast Packet: The counts of multicast packet.
•
click
Apply
button to apply the configuration.
Figure 3.23: Port Statistics
Port Control
In Port control, you can view every port status that depended on user setting and the negotiation result.
• Port: select the port that you want to configure.
• State: current port status. The port can be set to disable or enable mode. If the port setting is disable
then will not receive or transmit any packet.
• Negotiation: set auto negotiation status of port.
• Speed: set the port link speed.
• Duplex: set full-duplex or half-duplex mode of the port.
• Flow Control: set flow control function is Symmetric or Asymmetric in Full Duplex mode. The default
value is Symmetric.
• Security: when its state is “On” that means this port accepts only one MAC address.