Filter
Top Products
AMF Commands
AMF Software Reference Supplement for Allied Telesis x-Series Switches
106 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-1.4 and later C613-50031-01 REV B
switchport atmf-link
This command enables you to configure a port or aggregator to be an AMF uplink/
downlink. Running this command will automatically place the port or aggregator into
trunk mode.
The “no” variant of this command removes any AMF-link that may exist for the selected
port or aggregated link.
Syntax switchport atmf-link
no switchport atmf-link
Mode
Interface
Example To make a switchport 1.0.1 an ATMF crosslink, use the following commands
Parameter Description
switchport The Layer 2 Interface
atmf-link Sets the switchport to be an AMF link.
Node_1#
configure terminal
Node_1(config)#
int port 1.0.1
Node_1(config-if)#
switchport atmf-link