Filter
Top Products
AMF Commands
AMF Software Reference Supplement for Allied Telesis x-Series Switches
C613-50031-01 REV B AlliedWare Plus
TM
Operating System - Software Version 5.4.3-1.4 and later 65
atmf management vlan
The AMF management VLAN is created when the AMF network is first initiated and is
assigned its default VID of 4092. This command enables you to change the VID from this
default value.
The AMF management vlan is one of the internal VLANs that are used to communicate
information about the state of the AMF network between nodes. AMF uses its internal
VLANS (such as the management VLAN and the domain VLAN) to communicate its inter
nodal network status information. These VLANs must be reserved for AMF and not used
for other purposes.
If you assign a VLAN ID to this VLAN (i.e. change its value from the default of 4092) then
you will need to do this separately on every device within the AMF. The AMF management
subnet will then be applied to this new VID when all devices within the AMF network are
next rebooted.
Syntax atmf management vlan <2-4090>
no atmf management vlan
Default
The default VLAN ID for the AMF is 4092.
Mode Global Configuration
Usage You can use this command to change the management VLAN to meet your network’s
requirements and standards, particularly in situations where the default address value is
unacceptable.
Examples To change the AMF management VLAN to 4090 use the following commands:
Parameter Description
atmf management vlan The VLAN that is assigned for AMF management.
<
2-4090> The VID assigned to the AMF management VLAN.
Note
Although the value applied by default lies outside the user configurable range.
You can use the “no” form of this command to reset the VLAN to its default value.
Note
This VLAN will automatically be assigned an IP subnet address based on the
value configured by the atmf management subnet command on page 63.
Refer to this command description for further details.
VCF-1#
configure terminal
VCF-1(config)#
atmf management vlan 4090