Filter
Top Products
How to Configure and Use AMF on Allied Telesis Switches | Page 19
Configuring AMF
Configuring AMF
The following configuration example uses a simplified network to explain the steps required
to configure AMF.
Simple AMF example with a single master
Figure 4: Simple AMF network
Configuration AMF Master
awplus#conf t
awplus(config)#hostname AMF_Master
Host names are used as the AMF node name and must be unique within the AMF network.
AMF_Master (config)#atmf network-name atmf1
Note:
The AMF network name must be the same on all nodes within the AMF network, and
the device must be rebooted before the AMF network name takes effect.
AMF_Master (config)#atmf master
An AMF network must have at least one master configured. A licence is required for each
AMF master in the AMF network. If an AT-x8100 with dual CFCs is configured as an AMF
master a licence is only required on the CFC master, as the licence with be synchronized
Member 1
Member 2
Member 4
Member 3
port1.0.1
Crosslink
Link
port1.1.3
port1.1.3
port1.0.1
port1.1.2
port1.1.2
port1.1.1
port1.1.2
port1.1.1
port1.1.1
AMF
Master 1
1. Set the host name.
2. Set the AMF network name.
3. Configure the device as the AMF master.