Filter
Top Products
Site Planning: Basic Installation Procedure
InfraStruXure System—Installation and Start-Up 15
7. Connect utility conductors to the PDU.
A licensed electrician must connect utility power.
8. Connect AC power and control wiring.
9. Connect DC power wiring.
10. Connect an EPO switch to the PDU user connection plate.
11. Connect user input contacts and relay outputs to the PDU user connection plate, if applicable.
12. Install Shielding Troughs, Shielding Partitions, and Cable Ladders.
13. Install the Rack Automatic Transfer Switches (ATS), Rack Power Distribution Units, and other
InfraStruXure rack-mount devices.
14. Route and attach power cables to RDPs and to each Rack ATS and/or Rack PDUs.
15. Route and attach communication cables to the InfraStruXure Manager hub (or switch).
See als
o
For instructions, see Certified Electrician’s Instructions (990-1469A) included
with your InfraStruXure PDU documentation.
See page 26 for detailed instructions.
See page 30 for detailed instructions.
See page 33 for detailed instructions.
See page 37 for detailed instructions.
See page 39 for general information.
See als
o
For detailed information and grounding instructions, see the instruction sheet
included with the Shielding Troughs and Shielding Partitions
(990-1393B).
See als
o
For more information on installing and grounding the Cable Ladders see the
instruction sheet included with the cable ladders (990-1576).
See als
o
For instructions, see the manuals included with your Rack ATS, Rack PDU, or
other InfraStruXure rack-mount device.
See page 41 for detailed instructions.
See page 46 for detailed instructions.