Filter
Top Products
InfraStruXure System—Installation and Start-Up 41
Install InfraStruXure Rack-Mount Devices
Install the Rack Automatic Transfer Switches (ATS)
Install a Rack ATS in the top of each enclosure for overhead wiring, and in the bottom of each
enclosure for wiring under the floor.
The Rack ATS is an optional component and not all InfraStruXure systems will include them.
Install the Rack Power Distribution Units (PDU)
Install Rack PDUs in the rear of the NetShelter VX enclosure, in the channel directly behind the rear
vertical mounting rails. For overhead wiring, make sure that the power cord is pointing toward the
roof of the enclosure. For under the floor wiring, make sure that the power cord is pointing toward the
floor.
Install the InfraStruXure Manager and Hub (or Switch)
Install the InfraStruXure Manager in the enclosure closest to the InfraStruXure PDU. The CAT-5 data
cables included with your configuration are of varying lengths, based on the distance components
will be installed from the InfraStruXure PDU.
Install the Environmental Monitoring Unit or Environmental Management System
Install the Environmental Monitoring Unit or Environmental Management System according to the
installation instructions included with the device. The Environmental Monitoring Unit and
Environmental Management System are optional components and not all InfraStruXure systems will
include them.
See als
o
See the installation instructions in the manual included with your Rack ATS.
See als
o
See the installation instructions in the manual included with your Rack PDU.
See als
o
See the installation instructions in the manual included with your InfraStruXure
Manager.