Filter
Top Products
Page 28 MX28B200/400 –48 VDC User’s Manual (990-9133)
Parameter Locations, Descriptions, and Default Values
The location, description, and factory programmed default value for each of the
MX28B system parameters is found in the table below. The table also shows all of
the status and information screens with typical displays. The location of a parameter
screen is shown in brackets, for example: [SYSTEM/IN-RLY/RLY-MAP]. To find the
parameters that can be accessed in this category, starting from the main menu
screen, do the following:
1) Use the right or left arrow keys to position the cycling cursor below “SYSTEM”.
2) Press the down arrow key once.
3) Use the right arrow key to position the cycling cursor below “IN-RLY”.
4) Press the down arrow key once; the cursor will be cycling below “RLY-MAP”.
5) Press the down arrow key (repeatedly if necessary) until the desired parameter
screen is displayed (there are eight parameter screens in this category).
After making any desired changes, return to the main menu press the up arrow key
repeatedly.
If a parameter requires a level 1 or level 2 security access to permit changes to it, the
security level will be found in braces, i.e. Security Level {2}, in the “PARAMETER” column
of the table.
Parameter Locations, Descriptions, and Default Values
PARAMETER NAME/
[MENU LOCATION]
DESCRIPTION DISPLAY SCREENS /
DEFAULT SETTINGS
Address 1
Security Level {1}
[SYSTEM/SETUP]
Power plant address or identification -
first line.
Address 1 m+
APC DCNS, Inc.
Address 2
Security Level {1}
[SYSTEM/SETUP]
Power plant address or identification -
second line.
Address 2 m+
11035 Switzer Av
Address 3
Security Level {1}
[SYSTEM/SETUP]
Power plant address or identification -
third line.
Address 3 m+
Dallas, TX.
Alarms Item 1
{Status Only}
[ALARMS]
•
•
•
Alarms Item 16
[ALARMS]
Display of up to 16 active alarms (a
typical alarm screen is shown).
•
•
•
Display of up to 16 active alarms (a
typical alarm screen is shown).
Alarm Item 1 +
Batt LV Alm Onm
•
•
•
Alarm Item 16 +
No Alarms
Battery Current
{Status Only}
[STATUS]
Battery current measured by the system
controller at the battery current shunt.
Batt Current +
-15.0 A