Filter
Top Products
60kW InfraStruXure PDU—Operation and Configuration 39
How to Access a Network Management
Interface on a Configured InfraStruXure PDU
Web interface
As your browser, you can use Microsoft
®
Internet Explorer 5.0 (and higher) or Netscape
®
4.0.8 (and
higher, except Netscape 6.x) to access the InfraStruXure PDU through its Web interface. Other
commonly available browsers also may work but have not been fully tested by APC.
To use the Web browser to configure InfraStruXure PDU options or to view the event log, you can
use either of the following:
• The HTTP protocol (enabled by default), which provides authentication by user name and
password but no encryption.
• The more secure HTTPS protocol, which provides extra security through Secure Sockets Layer
(SSL) and encrypts user names, passwords, and data being transmitted. It also provides
authentication of Network Management Cards by means of digital certificates.
To access the Web interface and configure the security of your device on the network:
1. Address the InfraStruXure PDU by its IP address or DNS name (if configured).
2. Enter the user name and password (by default, apc and apc for an Administrator, or device and
apc for a Device Manager).
3. Select and configure the type of security you want. (This option is available only for
Administrators.)
Telnet and SSH
You can access the control console through Telnet or Secure SHell (SSH), depending on which is
enabled. (An Administrator can enable these access methods through the Telnet/SSH option of the
Network menu.) By default, Telnet is enabled. Enabling SSH automatically disables Telnet.
Note
Disregard the procedures in this section if you have the APC InfraStruXure
Manager as part of your system. See the InfraStruXure Manager’s Installation
and Quick-Start manual for access information.
See als
o
See the chapter entitled “Security” in the InfraStruXure PDU’s online Network
Management User’s Guide for information on choosing and setting up your
network security. Use the Web/SSL option of the Network menu to enable or
disable the HTTP or HTTPS protocols.