Filter
Top Products
60kW InfraStruXure PDU—Operation and Configuration 45
How to Add Circuit Breakers and Power
Cables
Add a circuit breaker on the PDU
1. Move the clip on the back of the circuit breaker to correspond to the phase to which you are
connecting to (L1, L2, or L3).
2. Snap the new single-pole circuit breaker into a position on the panel.
3. Remove the corresponding plastic blanking plate on the front panel of the PDU.
Add a power cable to the PDU
Before adding a power cable, add a circuit breaker:
1. Install a strain-relief connector in
any available knockout on the roof
of the PDU.
2. Slide enough of the power cable
through the strain-relief connector to
reach the new circuit breaker.
3. Tighten the strain-relief connector.