Filter
Top Products
Installing the Wireless Router
4
INSTALLING THE WIRELESS ROUTER
Before installing the APC’s Wireless Mobile Router, ensure the items
listed under “Package Contents” are available. If any item is missing or
damaged, contact the place of purchase or a local APC distributor. Also
ensure that all the necessary cabling is in place before installing the
Wireless Mobile Router.
Hardware Description
APC’s Wireless Mobile Router can be connected to the internet using a
Wide Area Network (WAN) port. Use the WAN port for connection to a
10BASE-T/100BASE-TX ethernet LAN. It can auto-negotiate the
operating speed to 10/100 Mbps, and the mode to half/full duplex. This
port can be connected directly to a PC or to a server equipped with an
ethernet network interface card via a crossover cable, or to a networking
device such as an ethernet hub or switch. This WAN port can also be
used for a connection to a Digital Suscriber Line (DSL) or cable modem
(WAN). Refer to Figure 2 and Table 2 for a description of the two
connectors on the Wireless Mobile Router.
Figure 2. Wireless Mobile Router Rear Panel Connectors
Power Connector RJ-45 Port
WAN Port
Power Connector