Filter
Top Products
Installation Procedure
7
Installation Procedure
The Wireless Mobile Router can be positioned at any convenient
location in the home or office. No special wiring or cooling requirements
are needed. However, APC recommends the following guidelines:
• Keep the Wireless Mobile Router away from heat.
• Do not place the Wireless Mobile Router in a dusty or wet
environment.
To install the Wireless Mobile Router (Figure 3), proceed as follows:
1. Connect the Category 6 (CAT6) ethernet cable provided with the
Wireless Mobile Router to the LAN/WAN port on the network
(providing internet access, e.g., xDSL modem or cable modem) to
the WAN connector at the rear of the Router.
Caution: Do not plug a phone jack connector into any RJ-45 port, as
this may damage the Router. Instead, use twisted-pair cables having
RJ-45 connectors that conform to Federal Communications
Commission (FCC) standards.
.
Figure 3. Connecting the Wireless Mobile Router
Internet
Access
Device
Wireless
Router
Cable/DSL
Broadband
Notebook with
Wireless PC Card
Desktop PC with
Wireless PCIAdapter
Internet