Filter
Top Products
61
VSI-Pro VIDEO SERIAL INTERFACE
ADDRESS SELECTION
Each Regcom unit on the RS-485 network must be set with a unique network address.
The address is selected using switches 1-5 from the bank of DIP switches on the rear of the unit. The address must
correcspond to the DVR channel number that the text is to be associated with.
The address must be set in binary code (see below), SW1 being the “least significant bit”.
LED STATUS INDICATION
Status light A illuminates whenever data is sent from the Regcom to the master unit .
Status light B illuminates to indicate the Regcom is correcly connectly connected via the RS-485 network to the
master unit.
Address No. SW1 SW2 SW3 SW4 SW5
1 ON OFF OFF OFF OFF
2 OFF ON OFF OFF OFF
3 ON ON OFF OFF OFF
4 OFF OFF ON OFF OFF
5 ON OFF ON OFF OFF
6 OFF ON ON OFF OFF
7 ON ON ON OFF OFF
8 OFF OFF OFF ON OFF
9 ON OFF OFF ON OFF
10 OFF ON OFF ON OFF
11 ON ON OFF ON OFF
12 OFF OFF ON ON OFF
13 ON OFF ON ON OFF
14 OFF ON ON ON OFF
15 ON ON ON ON OFF
16 OFF OFF OFF OFF ON
Figure 3C: Hydra / Regcom Front Panel
Figure 4C: Hydra / Regcom Rear Panel
Table 9C: Address Selection
HYDRA and REGCOM APPENDIX C