Filter
Top Products
Introduction
7
MVP-5200i Modero Viewpoint Widescreen Touch Panel
The navigation wheel may also be programmed to initiate specific commands. For more information,
please see the Programming section on page 103.
Intercom Microphone
The MVP-5200i contains a built-in microphone above the upper lefthand corner of the touch screen for
video and audio conferencing capabilities. This microphone is concealed by the casing.
Stylus
The MVP-5200i comes with a unique touchscreen stylus that slides into a storage groove on the right
side of the device when not in use. Replacement styluses may be ordered in a 3-pack (FG5966-30-xx)
from www.amx.com.
Kick Stand
Since the MVP-5200i device is designed to be a unit used away from its charging station, it has an
extendable "kickstand" on the back of the unit (FIG. 2). This may be opened by physically lifting the free
end of the kick stand away from the device. The device may then be propped up on a flat surface and
accessed in a normal fashion.
Navigation Wheel behavior in each Power Mode (Cont.)
Power Mode Power
Status
Enters Mode By - Exits Mode By - LED Behavior
(Sleep Blink
Setting)
Notes
Enabled Disabled
Stand By
(Display Off,
Electronics
halted)
Battery
Power
Enabled Advanced
Power Management
1. Display TimeOut
setting reached
2. Sleep Send
Command
1. Apply External
Power
2. Touch Display
3. WakeUp Send
Command
Off OFF External
Power will
transition
unit to
Sleep Mode
in < 10
seconds.
Stand By
(Display Off,
Electronics
halted)
External
Power
N/A Same as Sleep
Mode
OFF OFF
Stand By
(Display Off,
Electronics
halted)
Charging N/A Same as Sleep
Mode
OFF OFF
Shut Down (Off) Battery
Power
1. Panel Shutdown
setting reached
2. Panel Shutdown
button pressed
3. Navigation Wheel
button held
1. Apply External
Power
2. Press and hold
Navigation Wheel
button
OFF OFF External
Power will
transition
unit to
Awake
Mode after
boot up
Shut Down (Off) External
Power
N/A Same as Sleep
Mode
OFF OFF
Shut Down (Off) Charging N/A Same as Sleep
Mode
OFF OFF