Filter
Top Products
Windows 2000 will automatically install the ADSP-21535 EZ-KIT Lite driver.
The driver installation is now complete as shown in Figure 2-14.
Figure 2-14: Completing Driver Installation Dialog Box
8. Click Finish to exit the wizard.
Verify the installation by following the instructions in section 2.4.6.
2.4.6 Verifying Driver Installation
Before you use the EZ-KIT Lite evaluation system, verify that the USB driver
software is installed properly:
1. Ensure that the USB cable is connected to the evaluation board and the PC.
2. Verify that the yellow USB monitor LED (LED5) is lit. This signifies that the
board is communicating properly with the host PC and is ready to run
VisualDSP++.
ADSP-21535 EZ-KIT Lite Evaluation System Manual
2-14