Filter
Top Products
4.5.1 Expansion Interface (P1, P2, P3)
Three board-to-board connector footprints provide the signals for most of the DSP
peripheral interfaces. Analog Devices does not populate these connectors or
provide any additional support for this interface. See section 4.2.3, for more
information on the Expansion Interface. Contact Samtec for the availability and
pricing of these connectors.
Part Description Manufacturer Part Number
90 Position 0.05” Spacing (P1,
P2, P3)
Samtec SFM-145-01-S-D
Mating Connector
90 Position 0.05” Spacing
(Through Hole)
Samtec TFM-145-x1 Series
90 Position 0.05” Spacing
(Surface Mount)
Samtec TFM-145-x2 Series
90 Position 0.05” Spacing (Low
Cost)
Samtec TFC-145 Series
4.5.2 FlashLINK (P4)
The FlashLINK connector allows you to configure and program the
STMicroelectronics DSM2150 flash/PLD chip. See section 3.5, for more
information about using the FlashLINK connector.
Part Description Manufacturer Part Number
Right-angle 7X2 Shrouded 0.1
spacing
TYCO 2-767004-2
Mating Assembly
FlashLINK
TM
JTAG
Programmer
ST Micro FL-101B
4.5.3 Audio (P5, P6)
There are two 3.5mm stereo audio jacks: one input, and one output.
Part Description Manufacturer Part Number
3.5mm stereo jack (P5, P6) Shogyo SJ-0359AM-5
Mating Cable
3.5mm stereo plug to 3.5mm
stereo cable
Radio Shack 42-2387A
ADSP-21535 EZ-KIT Lite Evaluation System Manual
4-12