Filter
Top Products
9Smart-UPS VT ® 10-40 kVA 380/400/415 V, 208/220 V, 200/208 V Battery Installation
Note: The U-shaped interconnection brackets are 1-2 mm higher than the opening below the
enclosure to inactivate the casters. Therefore, the enclosure must be tilted when placing the U-
shaped interconnection brackets under the enclosure.
3. In each side of the same enclosure insert a
maximum of nine and a minimum of two M8
screws (not provided) through holes in the
bottom of the enclosure and through holes in the
U-shaped floor anchoring brackets, and into the
pre-drilled floor holes.
Note: See “Prepare for Floor-Anchoring
(optional)” on page 2 if the floor has not been prepared for anchoring.
4. Fasten the screws.
5. Move the adjacent enclosure on its
casters close to the enclosure with the U-
shaped floor anchoring brackets.
Note: If the additional enclosure is on
its levelling feet, use a forklift or pallet jack to move it into position.