Filter
Top Products
21Smart-UPS VT ® 10-40 kVA 380/400/415 V, 208/220 V, 200/208 V Battery Installation
Install battery-securing and floor-anchoring brackets
1. Install the batteries by pushing them all the way into the enclosure.
2. If required, install the battery securing brackets to hold the batteries firmly in place. Note! Do not
install the bracket the same way they were positioned when the enclosure arrived. Rotate the
brackets 180º and reinstall.
Note: Battery securing brackets are delivered with the UPS or XR Battery Enclosure and
installed in front of the batteries. Extra battery securing brackets for additional batteries can be
purchased. Refer to kit SUVTOPT003: APC Smart-UPS VT Battery Lock Kit for one Battery
Module.
3. Install the L-shaped floor-anchoring bracket (reuse of transportation brackets) by adding four M6
screws and nuts (provided) to the enclosure (only if the optional U-shaped floor anchoring
brackets described in this manual have not been chosen).
4. Drill floor holes.
Note: If the floor has not been prepared for anchoring, see “Prepare for Floor-Anchoring
(optional)” on page 2.
5. Add a minimum of two M8 screws (not provided) to the anchoring bracket and tighten the
screws.
Battery securing bracket
L-shaped floor-anchoring
bracket (reuse of
transportation bracket)