Filter
Top Products
Smart-UPS VT ® 10-40 kVA 380/400/415 V, 208/220 V, 200/208 V Battery Installation22
Reinstall the Enclosure Plates
Reinstall the cable landing cover plates and the bottom plates
1. Reinstall the cable landing cover plates on the XR Battery Enclosure(s)
2. Install the upper part of the conduit box (if applicable) on all enclosures.
3. Reinstall the bottom plates on the UPS and the XR Battery Enclosure(s).
Reinstall the top cover, battery compartment cover, and the front panel
1. Reinstall the top cover by fastening the
four screws at the front and the two
screws at the back.
2. Reinstall the battery compartment cover
(only applicable to Japanese
configurations) by placing the taps in the
slots at the bottom of the enclosure and at
the top of the enclosure.
3. Attach the battery compartment cover
with M6 screws to the inner side panels
in both sides.
5. Reinstall the front panel by inserting
the two taps at the bottom of the front
panel into the two slots at the bottom
of the enclosure.
6. Push the front panel forward until it
engages the locking devices at the
top of the enclosure.
7. Use a screwdriver to set the lock
mechanism to the locked position