Filter
Top Products
MacBook (13-inch) Take Apart — Subwoofer with Right Speaker Cable 146
Replacement Note: When connecting the right speaker cable to the logic board, make sure
the cable runs securely
• over the right memory slot
• between the optical drive cable connector and the LVDS cable connector
• under the Bluetooth connector
• between the fan and the midframe, and is anchored to the top of the midframe with a
mesh tab
Replacement Note: Before installing the subwoofer, check the bottom case to make sure
the microphone cable is to the right of the LVDS cable, between the LVDS cable and the
Bluetooth board.
Replacement Note: Before securing the subwoofer screws, place the subwoofer into the
bottom case, but tilt it up slightly to tuck these cables under the subwoofer tabs and above
the raised tabs on the bottom case:
• Microphone cable rst
• Bluetooth cable second
• Speaker cable third
• LVDS cable fourth
• no cables obscure the subwoofer screw posts on the bottom case
• the right speaker cable is routed correctly in the right corner of the bottom case and is
taped where shown.
Replacement Note: Install the subwoofer screws only when you are sure that the cables
cannot be pinched and are in the orientation specied. After the subwoofer screws are
installed, install the grounding screws and tabs on the midframe