Filter
Top Products
MacBook (13-inch) Additional Procedures — Mitsumi Keycaps — 315
6. With the stabilizer bar open, make sure the two ends of the slider bar are secured into the slots
in the keycap well.
7. Make sure the single-hinge mechanism on both ends of the keyboard well is fully at and
pressed as far as it will go away from the rubber dome. Then lower the keycap so that the three
clips align with the smaller stabilizer bar.
8. Lower the key down.
9. Press the major contact points, and then press over the entire key to hear it snap into place.
10. Check the Space bar key from all angles to make sure it is uniformly at. Press and release one
corner of the key. If it is installed correctly, the opposite corner should move at the same level.