Filter
Top Products
Trap Receivers
Page 6-15
Trap Receivers
This menu allows you to determine the management stations that will
receive traps from the SuperStack II Switch 1000.
▲ Important: Refer to the SuperStack II Switch 1000’s
User Guide for instructions on setting traps.
∆ Note: For instructions on using this menu, see “Managing
Trap Receivers” on page 4-12.
Table 6-10 describes each field in the Trap Receivers menu.
Table 6-10 Trap Receivers Menu
Field Description
Trap index Read-only field; displays the number of the trap
receiver entry.
Status Configurable field; displays the status of the trap
receiving station’s entry.
❏ active — trap receiving station’s entry is
active.
❏ notInService — trap receiving station’s entry is
not active (deletes the trap receiving station
when selected).
Note:
Refer to the SuperStack II Switch 1000’s MIB for
information on the other options available in this field.
Receiver Address Configurable field; displays the IP address of the man-
agement station that can receive traps.
Community String Configurable field; displays the write community
string of the receiving management station.
Category Configurable field; determines which traps are to be
received by the trap receiving station.
▲ Important: This is a 32-bit mask field.
❏ FF:FF:FF:FF — enables all traps
❏ ‘00000001’h — high priority configuration
traps.
❏ ‘00000002’h — low priority configuration traps
❏ ‘00000004’h — high priority security traps
❏ ‘00000008’h — low priority security traps
❏ ‘00000010’h — alarms and polling traps
book Page 15 Thursday, September 4, 1997 3:47 PM