Filter
Top Products
ASUS A7V400-MX SEASUS A7V400-MX SE
ASUS A7V400-MX SEASUS A7V400-MX SE
ASUS A7V400-MX SE
2-112-11
2-112-11
2-11
Primary/Secondary IDE Master/SlavePrimary/Secondary IDE Master/Slave
Primary/Secondary IDE Master/SlavePrimary/Secondary IDE Master/Slave
Primary/Secondary IDE Master/Slave
Primary IDE Master/Slave [Auto]Primary IDE Master/Slave [Auto]
Primary IDE Master/Slave [Auto]Primary IDE Master/Slave [Auto]
Primary IDE Master/Slave [Auto]
Secondary IDE Master/Slave [Auto]Secondary IDE Master/Slave [Auto]
Secondary IDE Master/Slave [Auto]Secondary IDE Master/Slave [Auto]
Secondary IDE Master/Slave [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, the setup BIOS automatically fills in the correct
values for the remaining fields on this sub-menu. If automatic detection
fails, this may be because the hard disk drive is too old or too new. If the
hard disk was already formatted on a previous system, the setup BIOS may
detect incorrect parameters. In these cases, select [Manual] to manually
enter the IDE hard disk drive parameters. If no drive is installed or if you are
removing a drive and not replacing it, select [None].
Configuration options: [None] [Auto] [Manual]
Access Mode [Auto]Access Mode [Auto]
Access Mode [Auto]Access Mode [Auto]
Access Mode [Auto]
The default [Auto] automatically detects an IDE hard disk drive. Select
[CHS] in coordination with the [Manual] setting of the Primary IDE Master in
to manually enter the hard disk drive values.
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.
Primary IDE Master
Primary IDE Master [Auto]
Access Mode [Auto]
Capacity 40020 MB
Cylinder 19158
Head 16
Sector 255
PIO Mode [Auto]
UDMA Mode [Auto]
Transfer Mode UDMA 5
F1 : Help
↑↑
↑↑
↑
↓↓
↓↓
↓ : Select Item -/+ : Change Value F5 : Setup Defaults
ESC : Exit
→←→←
→←→←
→←: Select Menu Enter : Select Submenu F10: Save and Exit
Select Menu
Item Specific Help
Press [Enter] to
select.