Filter
Top Products
2-122-12
2-122-12
2-12
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setup
[Manual] and [CHS] Settings[Manual] and [CHS] Settings
[Manual] and [CHS] Settings[Manual] and [CHS] Settings
[Manual] and [CHS] Settings
Manually enter the number of cylinders, heads and sectors per track for the
drive. Refer to the drive documentation or the drive label for this information.
After entering the IDE hard disk drive information into BIOS, use a disk
utility, such as FDISK, to partition and format new IDE hard disk drives. This
is necessary so that you can write or read data from the hard disk. Make
sure to set the partition of the Primary IDE hard disk drives to active.
After making your selections on this sub-menu, press the <Esc> key to
return to the Main menu. The Main menu displays the hard disk drive field
with your configuration.
Access Mode [Auto]Access Mode [Auto]
Access Mode [Auto]Access Mode [Auto]
Access Mode [Auto]
Select the hard disk drive type from this field. When Logical Block
Addressing (LBA) is enabled, the 28-bit addressing of the hard drive is
used without regard for cylinders, heads, or sectors. Note that LBA Mode is
necessary for drives with more than 504 MB storage capacity. Select [CHS]
to make manual entries for configuring the fields below.
Configuration options: [CHS] [LBA] [Large] [Auto]
CapacityCapacity
CapacityCapacity
Capacity
Displays the hard disk drive capacity in MB or GB. This item is non-configurable.
CylinderCylinder
CylinderCylinder
Cylinder
Configures the number of cylinders. Refer to the drive documentation to
determine the correct value.
Primary IDE Master
Primary IDE Master [Manual]
Access Mode [CHS]
Capacity 40020 MB
Cylinder [19158]
Head [ 16]
Sector [ 255]
PIO Mode [ Auto]
UDMA Mode [ Auto]
Transfer Mode UDMA 4
F1 : Help
↑↑
↑↑
↑
↓↓
↓↓
↓
: Select Item -/+ : Change Value F5 : Setup Defaults
ESC : Exit
→←→←
→←→←
→←
: Select Menu Enter : Select Sub-menu F10 : Save and Exit
Select Menu
Item Specific Help
Press [Enter] to
select sector
addressing method.