Filter
Top Products
ASUS P2B-D2 User’s Manual 53
IV. BIOS SOFTWARE
IV. BIOS
Power Management
PWR Up On Modem Act (Enabled)
This allows either settings of Enabled or Disabled for powering up the computer (turns the
ATX power supply on) when the modem receives a call while the computer is Soft-off.
NOTE: The computer cannot receive or transmit data until the computer and appli-
cations are fully running, thus connection cannot be made on the first try. Turning
an external modem off and then back on while the computer is off causes an initializa-
tion string that will also cause the system to power on.
AC PWR Loss Restart (Disabled)
This allows you to set whether you want your system to boot up after the
power has been interrupted. Disabled leaves your system off after reapply-
ing power and Enabled boots up your system after reapplying power.
Wake On LAN (Enabled)
This allows you to remotely power up your system through your network by sending
a wake-up frame or signal. With this feature, you can remotely upload/download data
to/from systems during off-peak hours. Enabled sets this feature.
IMPORTANT: This feature requires the optional network interface (see Network
Interface) and an ATX power supply with at least 720mA +5V standby power.
Automatic Power Up (Disabled)
This allows you to have an unattended or automatic power up of your system.
You may configure your system to power up at a certain time of the day by
selecting Everyday, which will allow you to set the time or at a certain time and
day by selecting By Date.
.....................................................................................................................................
Fan Monitor (xxxxRPM)
The onboard hardware monitor is able to detect the Chassis Fan Speed,
CPU Fan Speed, and the Power Supply Fan Speed in Rotations Per Minute (RPM).
Set to Ignore if one of these are not used so that error messages will not be given.
.....................................................................................................................................
Thermal Monitor (xxxC/xxxF)
The onboard hardware monitor is able to detect the CPU and MB (motherboard)
temperatures. Set to Ignore only if necessary.
.....................................................................................................................................
Voltage Monitor (xx.xV)
The onboard hardware monitor is able to detect the voltages put out by the
voltage regulators. Set to Ignore only if necessary.
NOTE: If any of the monitored items are out of range, an error message will appear:
“Hardware Monitor found an error, enter POWER MANAGEMENT SETUP for
details”. You will then be prompted to “Press F1 to continue, DEL to enter SETUP”.