Filter
Top Products
ASUS P2B-D2 User’s Manual 87
WINDOWS NT 4.0
Removing a Host Adapter from Windows NT v4.0
Removing a host adapter can be as simple as physically removing it from the slot
when your computer is shut down. Windows NT boots and functions properly in this
configuration, but a warning message is generated every time you boot Windows NT.
CAUTION! If you have removed a host adapter but still have other host adapt-
ers of the same type installed in your computer, do not use Windows NT Setup
to remove the device driver.)
To eliminate the warning message, you must update the Windows NT software con-
figuration, as described in the following steps:
1. Open the Control Panel, double-click on SCSI Adapters.
2. Select the Drivers tab.
3. Select the Driver you wish to remove.
a. For non-Ultra2 host adapters:
Select the driver you plan on removing and click Remove. The driver will
appear as one of the following:
Adaptec AHA290x/291x/294x/394x/4944/AIC78xx PCI SCSI Controller (NT 4.0)
or
Adaptec AHA-294x/AHA-394x/AHA-4944 or AIC-78xx PCI SCSI Controller (NT 4.0)
or
Adaptec AHA-294X/AHA-394X or AIC-78XX PCI SCSI Controller
b. For Ultra2 host adapters:
Select the driver you plan on removing and click Remove. The driver will
appear as one of the following:
Adaptec AHA-294xU2/AIC-7890/91 PCI Ultra2 SCSI Controller(NT 4.0)
4. If you are sure you are removing the correct host adapter type, click Yes.
5. You must restart your computer for the changes to take effect. Click Yes to re-
start your computer. Click No to return to the SCSI Adapters window.
WINDOWS NT 4.0
D. AIC-7890 Driver