Filter
Top Products
Chapter 2. Hardware Setup
15
SN0108 / SN0116 Sun Fire V100 Server Installation
For each Sun Fire V100 server you wish to install, refer to the Installation
Diagram on page 16 (the numbers in the diagram correspond to the numbers of
the steps), as you do the following:
1. Use standard Ethernet cable to connect any available port on the SN0108 /
SN0116's rear panel to an SA0141 adapter.
2. Use standard Ethernet cable to connect the V100's LAN port to an SA0142
adapter.
3. Connect the two adapters.
Note: If you choose to install a serial modem for OOB operation
(see Chapter 6), refer to step 3 of the PC installation procedure (see
page 11).
4. Plug the cable that connects the SN0108 / SN0116 to the network or the
Internet into its LAN port.
5. Use the AC power cord provided with this package to connect the SN0108
/ SN0116's Power Socket to an AC power source.
This completes the SN0108 / SN0116 installation.