Filter
Top Products
Chapter 2. Hardware Setup
17
SN0108D / SN0116D Sun Fire V100 Server Installation
For each Sun Fire V100 server you wish to install, refer to the Installation
Diagram on page 18 (the numbers in the diagram correspond to the numbers of
the steps), as you do the following:
1. Use standard Ethernet cable to connect any available port on the SN0108D
/ SN0116D's rear panel to an SA0141 adapter.
2. Use standard Ethernet cable to connect the V100's LAN port to an SA0142
adapter.
3. Connect the two adapters.
Note: If you choose to install a serial modem for OOB operation
(see Chapter 6), refer to step 3 of the PC installation procedure (see
page 13).
4. Plug the cable that connects the SN0108D / SN0116D to the network or
the Internet into its LAN port.
5. Connect the DC power source to the switch (refer to the installation
diagram for details).
6. Ground the switch.
This completes the SN0108D / SN0116D installation.