Filter
Top Products
Chapter 6 CLI – Layer 2
104 Avaya P332MF User’s Guide
Example:
P330-N# set port static-vlan 1/4-6 9
set port self-loop-discovery Admin_Status
Use the set port self-loop-discovery Admin_Status command to
enable or disable a port’s IBM token ring discovery mode. The port’s self-loop-
discovery feature is activated only after you enable the self-loop-discovery mode at
the module level using the set self-loop-discovery Admin_status
command.
Note: This command is not supported by the P330-ML switches.
The syntax for this command is:
set port self-loop-discovery Admin_Status <enable|disable>
<module/port>
Output Example:
P330-N# set port self-loop-discovery Admin_Status enable 1/2
Self-Loop-Discovery enabled on port 1/2.
set port channel
Use the set port channel command to enable or disable a Link Aggregation
Group (LAG) interface on the switch. LAG creation requires a LAG name to be
specified. There is no default name.
You can also add or remove a port from an existing LAG. When adding or removing
a port to an existing LAG, type the same LAG-name. All ports in the LAG are
configured with the parameters of the first port that is added to the LAG. These
parameters include port administrative status, speed, duplex, autonegociation
mode, VLAN ID, tagging mode, binding mode, and priority level.
The ports added to a LAG must belong to the same LAG group - refer to the “LAG”
marking on device’s front panel.
The syntax for this command is:
set port channel [port_list] [value] [name]
port_list Switch and ports to bundle (format: module/port)
value on/off to enable/disable a channel for the specified module
ports