Filter
Top Products
Chapter 6 CLI – Layer 2
Avaya P332MF User’s Guide 57
show port self-loop-discovery
Use the show port self-loop-discovery command to display which port or
switch has an enabled IBM™ token ring cable loop discovery status.
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
The syntax for this command is:
show port self-loop-discovery [module num/port number]
Output Example:
P330-N> show port self-loop-discovery 1/5
Self-Loop-Discovery is enabled on port 1/5.
show internal buffering
The show internal buffering command displays the size options (Maximum,
Minimum, or Medium) of the Receive (Rx) buffer allocated to each port of the
specified switch.
The syntax for this command is:
show internal buffering [<mod_num>]
Output Example:
P330-N> show internal buffering 1
Module Internal Buffer
------ ---------------
1 med
Note: Internal buffering for the P330-ML switches will always have the value Not
supported. This command is used to display the internal buffering status for the
other P330 switches in the stack.