Filter
Top Products
Chapter 6 CLI – Layer 2
Avaya P332MF User’s Guide 117
set ppp authentication incoming
Use the set ppp authentication incoming command to define the
authentication method used for a PPP server or client session.
The syntax for this command is:
set ppp authentication incoming {pap|chap|none}
Example:
P330-N(super)# set ppp authentication incoming chap
set ppp incoming timeout
Use the set ppp incoming timeout command to configure the number of
minutes until the system automatically disconnects an idle PPP incoming session.
The syntax for this command is:
set ppp incoming timeout <time>
Output Example:
P330-N> set ppp incoming timeout 15
PPP incoming session will automatically disconnect after 15
minutes of idle time
set ppp baud-rate
Use the set ppp baud-rate command to define the baud rate used in PPP sessions.
Note that the peer baud rate must be set at the same value as the host.
The syntax for this command is:
set ppp baud-rate <9600 | 19200 | 38400>
Example:
P330-N# set ppp baud-rate 38400
pap PAP authentication method
chap CHAP authentication method
none No authentication
time The timeout in minutes