Filter
Top Products
Chapter 3 Avaya P332MF Front and Back Panels
10 Avaya P332MF User’s Guide
COL Collision
OFF – No collision or FDX port
ON – Collision occurred on line
Tx Transmit to line
OFF – No transmit activity
ON – Data transmitted on line from the
module
Rx Receive from line
OFF – No receive activity
ON – Data received from the line into the
module
FDX Half/Full Duplex
OFF – Half duplex mode
ON – Full duplex mode
FC Flow Control
OFF – No Flow Control
ON – Symmetric/Asymmetric Flow Control
mode is enabled and port is in full duplex
mode.
Hspd High Speed 10/100
1000
OFF: 10 N/A
ON: 100 1000
LAG
Link Aggregation
Group (Trunking)
OFF – No LAG defined for this port
ON – Port belongs to a LAG
Table 3.2 Avaya P330 <- -> Select buttons
Description Function
Left/Right Individual – select LED function (see table above).
Reset module Press both right and left buttons together for approximately two
seconds. All LEDs on module light up until buttons are
released.
Reset stack Press both right and left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
FIV Force Initial Version – boot from backup initial version of the
Avaya P330 software, from Bank A (see Note below).
Table 3.1 Avaya P332MF LED Descriptions
LED Name Description LED Status