Filter
Top Products
3-2 Installation
AC Controls
(For all 15H Inverter, 21H Line Regen Inverter, 18H Vector, 22H Line
Regen Vector and 23H Servo).
Single Expansion Board Installation
Procedure:
1. Be sure drive operation is terminated and secured.
2. Remove all power sources from the control.
3. Wait at least 5 minutes for internal capacitors to discharge.
4. Remove the four (4) Phillips head screws (
1
/
4
turn) that secure the
control cover. (For A & B size, remove four screws that secure the
cover. On floor mounted G size enclosures, open the enclosure
door).
5. Remove the control cover.
6. Slide the expansion board male connector into the female
connector of the control board. See Figure
3-1.
7. Securely mount the expansion board to the sheet metal mounting
plate using the #6 screws provided in the installation hardware.
See Figure 3-2.
8. The mechanical installation of the expansion board is now
complete. Refer to Section 4 of this manual and configure the
jumpers as desired. Also complete the wiring before you proceed
to step 9.
9. When complete, install the control cover using the four (4) Phillips
head screws (
1
/
4
turn). (For A & B size, install four screws that
secure the cover. On floor mounted G size enclosures, close the
enclosure door).
10. Restore all power sources to the control.
11. Restore drive operation.