Filter
Top Products
Installing your Barco display controller
35
3. Unplug the computer’s power cord and disconnect all cables
from the back of your computer.
4. Remove the computer cover.
If necessary, consult your computer’s manual for help in
removing the cover.
5. If necessary, unscrew or unfasten and remove any existing
graphics card from your computer.
Note: If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a
multiple-display setup, disable it either in the computer’s
System Set-up utility (BIOS) or the Windows device manager.
6. Locate the appropriate slot and, if necessary, remove the metal
back-plate cover(s).
7. Align the display controller(s) for your B
ARCO Display System
with the slot(s) and press it(them) in firmly until the card(s)
is(are) fully seated.
8. Note: This step applies only to the MXRT 5100 and MXRT 7100.
Connect the power cable to the 6-pin power connection on the
graphics card. Make sure the cables are not interfering with
anything inside the computer (for example, a cooling fan).
Caution – Wait approximately 20 seconds after unplugging
the power cord before disconnecting a peripheral or
removing a component from the motherboard to avoid
possible damage to the motherboard.