Filter
Top Products
Installing your Barco display controller
38
If you have properly installed your graphics card, the Windows
start-up messages will appear once the boot procedure is
finished.
13. Install the drivers, QAWeb software and documentation for your
B
ARCO NIO Display System by following the instructions in the
section “Installing drivers and software” on page 49 of this
manual.
Your Barco display(s) will be running in a basic video
mode at a default refresh rate. Higher resolutions and
refresh rates, such as 1536x2048@60Hz, are not avail-
able at this stage of the installation. Once you have
installed the B
ARCO NIO Display System drivers and soft-
ware, the Barco monitor Plug and Play software should
automatically set the resolution for the displays of your
B
ARCO E-2320 C Display.