Filter
Top Products
Installation Guidelines
3-4
5975288 BARCOGRAPHICS 8200 110497
Installation Guidelines
5975288 BARCOGRAPHICS 8200 1104973-4
* Where to install the projector?
Definitions of the Abbreviation on drawings
B = Distance between ceiling and top of the screen or between
floor and bottom of the screen.
A = Correction value, distance between bottom side of projec-
tor and middle of the lens. Value to be subtracted from B to
obtain the correct installation position. (A value is a constant
value for all screen widths and type of lenses, A = 195 mm.)
CD = Total distance between projector and ceiling or projector
and floor.
SW = Screen width.
SH = Screen height (image height).
PD = Projector Distance, distance between screen and projec-
tor.
Inputs and computer video format input compatibility :
Some examples :
VIDEO and S-VIDEO
COMPONENT VIDEO
RGB ANALOG with STANDARD SYNC (SYNC ON GREEN or
SEPARATE SYNC)
RGB ANALOG with TRI-LEVEL SYNC (SYNC ON GREEN or
SEPARATE SYNC)
VGA : 640 x 480 pixels
MAC : 640 x 480 pixels
Super VGA : 800 x 600 pixels
XGA : 1024 x 768 pixels
up to 1280 x 1024 pixels
Sources with pixel clock < 135 MHz
Lens type selection.
a) determine the required screen width.
b) determine the approximate position of the projector in the projection
room with regard to the screen and measure the
projector-screen distance (PD).
c) refer to the lens diagrams to find the best corresponding PD
with regard to the measured projector-screen distance for the
required screen width.
The lens type is determined (lens name is indicated on top of the
page).
Start the installation procedure for the projector as described in
the manual.
* Where to install the projector?
Definitions of the Abbreviation on drawings
B = Distance between ceiling and top of the screen or between
floor and bottom of the screen.
A = Correction value, distance between bottom side of projec-
tor and middle of the lens. Value to be subtracted from B to
obtain the correct installation position. (A value is a constant
value for all screen widths and type of lenses, A = 195 mm.)
CD = Total distance between projector and ceiling or projector
and floor.
SW = Screen width.
SH = Screen height (image height).
PD = Projector Distance, distance between screen and projec-
tor.
Inputs and computer video format input compatibility :
Some examples :
VIDEO and S-VIDEO
COMPONENT VIDEO
RGB ANALOG with STANDARD SYNC (SYNC ON GREEN or
SEPARATE SYNC)
RGB ANALOG with TRI-LEVEL SYNC (SYNC ON GREEN or
SEPARATE SYNC)
VGA : 640 x 480 pixels
MAC : 640 x 480 pixels
Super VGA : 800 x 600 pixels
XGA : 1024 x 768 pixels
up to 1280 x 1024 pixels
Sources with pixel clock < 135 MHz
Lens type selection.
a) determine the required screen width.
b) determine the approximate position of the projector in the projection
room with regard to the screen and measure the
projector-screen distance (PD).
c) refer to the lens diagrams to find the best corresponding PD
with regard to the measured projector-screen distance for the
required screen width.
The lens type is determined (lens name is indicated on top of the
page).
Start the installation procedure for the projector as described in
the manual.