Filter
Top Products
RLS W12 02/12/2014
22
4.Input & Communication
Basic Remote Command
result
RCU action Remark
adjust aspect ratio press "aspect ratio"
ASPECT
RATIO
halt projection temporarily press "pause"
PAUSE
The pause button will have a picture mute with
shutter close
operate the OSD menu normally or not press "text"
TEXT
When text is set to on, user can operate the
OSD menu normally. If set to Off, only can
use ON, OFF, 1~5, SWAP, PIP and PAUSE these
function
resync the image press "auto image"
This function also apply to PIP input
adjust image contrast press "contrast"
1
adjust image brightness press "brightness"
adjust image sharpness press "sharpness"
adjust image phase press "phase"
When the image flicker, doubles, distorts or
appear wavy, use this function to adjust
adjust image color saturation press "color"
press "tint"
Only available when the input source is YUV1,
RGBHV/YUV2 or VGA
display or hide pip press "PIP"
PIP
swap the input source of PIP press "swap"
SWAP
change receiving address of the remote
control
press "address"
ADDRESS
*only 2 address are possible*
Press and hold the ENTER until the remote
control panel flash once(approximately 5
seconds) to change the receiving address of
the remote control. if you use one remote
control to operate 2 different projectors. You
can assign different address for the 2 projectors
so that when you operate projector A, projector
B will not be affected.
Range of effective remote control signal reception
The diagram below illustrates the range of effective remote control signal reception.
40°
25m
25m
40°
Avoid placing the remote control at places of high temperature or humidity as it could cause the remote
control to malfunction.