Filter
Top Products
RLS W12 02/12/2014
57
11.Alignment
Bottom Right Corner
Press ◄► to correct bottom right corner image bias.
→
Press ◄► to correct
bottom right corner image
bias to correct image.
Custom Warp
Press ◄► to ON/OFF. This function need to use with Barco Tool through LAN or RS-232.
Reset
It will reset all the warp functions to the default settings that is without any warp functions enabled.
11.13 Blanking
TOP
Press ▲▼on the remote control to adjust the top
blanking area on the projected image
Bottom
Press ▲▼on the remote control to adjust the bottom
blanking area on the projected image
Left
Press ◄►on the remote control to adjust the left
blanking area on the projected image
Right
Press ◄►on the remote control to adjust the right
blanking area on the projected image
Reset
It will reset all the blanking functions to the default
settings that is without any blanking functions enabled.
Use left blanking
function to block
the additional
image on the
screen
11.14 ScenergiX
The function of ScenergiX is applied in multiple projectors that are projecting at the same screen simultaneously to adjust the
uniformity of the images on the screen.
Status
Press ENTER to select ON or OFF. The function must be set to ON in order to enable the function of ScenergiX. If the function
is set to OFF, the function of ScenergiX is disabled.