Filter
Top Products
RLS W12 02/12/2014
31
5. Getting Started
5.3 Switching to standby
How to switch to standby
Press power button remain 3 seconds to switch to standby mode
All custom settings are written to the internal backup device. A message ’Saving data ...’ indicates
this process. Never switch off the projector while this message is displayed.
When switching to standby, an after cooling process will start to cool down the projector. The after cool
time depends on the temperature inside the projector and can vary from 30 second to 5 minutes.
5.4 Power off projector
How to power off
1.
Press first Standby.
2.
Let cool down the projector until the fan speed decreases. At least 5 minutes.
3.
Switch off the projector with the power switch. ’0’ must be pressed.
CAUTION: Never switch off the projector while the message ’Saving data ... ’ is displayed !
5.5 Source selection
Press MENU on the remote control to activate OSD then select INPUT for the desired source. Or press on the
keypad to select the input source.
5.6 Changing OSD language
By factory default, the OSD menu of the projector is displayed in English. If you want to change default language. Press the
MENU on Remote control or keypad, then go to Control -> Languages to select the language that you want.