Filter
Top Products
RLS W12 02/12/2014
30
5. Getting Started
5. GETTING STARTED
Overview
•
RCU & Local keypad
•
Power on projector
•
Switching to standby
•
Power off projector
•
Range of effective remote control signal reception
•
Source selection
•
Changing OSD language
•
Adjusting the lens by horizontal and vertical lens shift
•
Introduction the OSD Lite on screen
5.1 RCU & Local keypad
How controlling the projector ?
The projector can be controlled by the local keypad or by the remote control unit.
Location of the local keypad ?
The local keypad is located on the rear side of the projector.
Remote control functions.
This remote control includes a battery powered infrared (IR) transmitter that allows the user to control the projector remotely.
This remote control is used for source selection, control, adaptation and set up.
5.2 Power on projector
How to power on.
Press the power switch at the side of the projector to switch on this projector.
- When ’0’ is pressed, the projector is switched off.
- When ’1’ is pressed, the projector is switched on.
The projector starts up in standby.
When the projector is turned off, it is required to wait for at least 90 seconds to re-start the projector to
complete the cooling of lamp.
Starting image projection via the standby key.
Press
STBY
key once on the local keypad or on the remote control.