Filter
Top Products
71
3
Award BIOS Setup Utility
Super IO Device
Move the cursor to this field and press <Enter>. The following fields
will appear.
Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto The system will automatically select an I/O address
for the onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3 Allows you to
manually select an I/O address for the onboard
serial port 1 and serial port 2.
Disabled Disables the onboard serial port 1 and/or serial
port 2.
SC Port Address/IRQ (PM11-UL/RAMA only)
This field is used to select the SC ports address and IRQ. When
selecting an address for the SC port, the IRQ will at the same
time appear next to the address selected.
MS Port Address/IRQ (PM11-UL/RAMA only)
This field is used to select the MS ports address and IRQ. When
selecting an address for the MS port, the IRQ will at the same
time appear next to the address selected.
SD Port Address/IRQ (PM11-UL/RAMA only)
This field is used to select the SD ports address and IRQ. When
selecting an address for the SD port, the IRQ will at the same
time appear next to the address selected.
Important:
IRQs for Serial Port 1, Serial Port 2, Parallel Port, SC Port, MS
Port and SD Port must be appropriately selected making
sure each port uses a different IRQ. When selecting a port
address for SC Port, MS Port and SD Port, the IRQ will at the
same time appear next to the address selected. For
example, if you selected 700/3 for the SC port, 700 is
the ports address and 3 is its IRQ. Therefore you must
not select IRQ 3 for the other ports.