Filter
Top Products
79
3
Award BIOS Setup Utility
Resume on PCI Event
If you are using the Wake-On-USB Keyboard/Mouse function
with a device that is connected to the USB 2.0 port, set this
field to Enabled. This function allows you to use a USB keyboard
or USB mouse to wake up a system that is in the S3 (STR -
Suspend To RAM) state.
You must also set this field to Enabled if your PCI card such as
LAN card or modem card uses the PCI PME (Power
Management Event) signal to remotely wake up the PC. Refer to
the cards documentation for more information.
Resume On LAN/Ring
This field allows you to enable the Wake-On-LAN and Wake-On-
Ring functions.
If you are using a LAN card that supports the remote wake
up function, set this field to Enabled. The will allow the network
to remotely wake up a Soft Power Down (Soft-Off) PC.
However, if your system is in the Suspend mode, you can wake
up the system only through an IRQ or DMA interrupt. Your
LAN card must support the remote wake up function. Refer
to Wake-On-LAN Connector in chapter 2 for more
information.
When enabled, the system will power-on to respond to calls
coming through an external or internal modem. Refer to Wake-
On-Ring Connector in chapter 2 for more information.
Resume on Alarm
Enabled When Enabled, you can set the date and time you
would like the Soft Power Down (Soft-Off) PC to
power-on in the Date (of Month) and Resume
Time (hh:mm:ss) fields. However, if the system is
being accessed by incoming calls or the network
prior to the date and time set in these fields, the
system will give priority to the incoming calls or
network.
Disabled Disables the automatic power-on function. (default)