Filter
Top Products
91
4
Supported Software
4.1 Desktop Management Interface (DMI)
The mainboard comes with a DMI built into the BIOS. DMI, along with
the appropriately networked software, is designed to make inventory,
maintenance and troubleshooting of computer systems easier. With DMI,
a network administrator or MIS engineer can remotely access some
information about a particular computer system without physically going
to it. Quite often a service call may be unnecessary as the problem
can be solved remotely.
The DMI utility in the BIOS automatically records various information
about your system configuration. Information about the type and speed
of CPU, type and amount of memory for each memory slot, BIOS
revision level, types of add-in PCI boards and components, certain re-
vision numbers of hardware installed, etc. are automatically detected
and stored in the DMI pool, which is a part of the mainboard's Plug
and Play BIOS. Additional information, such as ISA based peripherals,
which may not be automatically detected, can be manually recorded
in the DMI pool by using the Add DMI menu. The DMI pool data is
then verified or updated whenever the system hardware or setup is
altered.
4.1.1 Running the DMI Utility
To run the DMI utility, type: DMICFG.EXE.
The DMI utility must run in real mode with at least 180K of base
memory. Memory managers like HIMEM.SYS (required by Windows)
must not be installed. You may do this by using one of the 3 meth-
ods listed below.
1. Boot up from a system diskette without the AUTOEXEC.BAT and
CONFIG.SYS files,
2. REM HIMEM.SYS in the CONFIG.SYS, or
3. Press <F5> during bootup to bypass your AUTOEXEC.BAT and
CONFIG.SYS files.
Chapter 4 - Supported Software