Filter
Top Products
Chapter 3: Installation
724-746-5500 | blackbox.com
Page 15
COM 3
2
1
Figure 3-2. Connecting Category 5, 5e or 6 cable from LAN / network switch.
3.2 Connections
The ServSwitch iPATH server unit is supplied fully pre-loaded and permits no local user interaction. All configuration takes place
remotely via the network connections and as a result only two connections are required: Network and power.
3.2.1 Network Connections
The ServSwitch iPATH server has two network connections on the rear panel, labeled 1 and 2. These allow the unit to be
connected to internal and external network connections as required. The external network connection allows admin users located
away from the internal network to be able to login.
1 Run a category 5, 5e, or 6 link cable from the appropriate hub or router to the ServSwitch iPATH server unit.
2 Connect the plug of the link cable into the IP port labeled 1 on the rear panel of the ServSwitch iPATH server unit,
as shown in Figure 3-2: