Filter
Top Products
140 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
CLI Command Modes
The commands available are divided in three categores (Unit, Kernel, and Routing) and arranged in
a hierarchy. Each of the three modes has its own set of commands and its own sub modes of
hierarchy.
The commands available for each routing protocol (RIP and OSPF) are separated into several
modes and arranged in a hierarchy. Enable is the default mode and is the lowest level. Each mode
has its own special commands; in some modes, commands from a lower level are available..
When you enter the CLI, the following prompt is displayed:
Access Router CLI, type
Unit to enter Unit mode
Kernel to enter kernel mode
Rip to enter RIP mode
Ospf to enter OSPF mode
Quit to exit
[Unit/Kernel/Rip/Bgp/Ospf]:
Parameter expansion For the area virtual-link command, the AREAADDRESSID
parameter is replaced by either an IP address or a number in the given range:
AREAADDRESSID=A.B.C.D|<0-4294967295>
The minimum command then is:
area 1.1.1.1 virtual-link 2.2.2.2
The parameters in the string (AUTHENTICATE|MSGD|INTERVAL) are
optional. Each one of which is replaced by more keywords and values.
Table E-3 CLI command modes
Mode Description
Enable This mode is the base mode from where users can perform basic commands like show, exit,
quit, help, list, enable. This mode also includes some debugging command, the save
commands (for saving and viewing the configuration), show protocol specific information,
and so on.
Enable is the default mode.
Configure Sometimes referred to as Configure Terminal, this mode serves as a gateway into the Interface
and Router.
Interface This mode makes protocol-specific configuration commands accessible.
router Sometimes referred to as configure-router mode, this mode available for the RIP and OSPF
protocols, makes available router and routing commands.
Line Used for access-class commands. It is available for the OSPF and RIP protocols.
Route-map Mode used to set route metric, route-length and cost data. It is available for the OSPF and RIP
protocols.
Table E-2 Router CLI Help
Topic Description