Filter
Top Products
178 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
Command Mode
Route-map mode
Usage
To set the conditions for redistributing routes from one routing protocol to another, use the match and set route-mapconfiguration
commands. The match commands specify the match criteria under which redistribution is allowed for the current route-map. The
set commands specify the set redistribution actions to be performed, if the match criteria are met.
If a route does not match the criteria completely, it will not be advertised for outbound route maps and neither be accepted for
inbound route maps. You can modify the data by configuring a second route map section with an explicit match specified.
Use the match tag command to match the specified tag value.
Examples
ospfd# configure terminal
ospfd(config)# route-map mymap1 permit 10
ospfd(config-route-map)# match tag 100
Related Commands
match metric, match route-type external
neighbor
Use the neighbor command to configure OSPF routers interconnecting to non-broadcast networks.
Use the no form of this command to remove a configuration.
Command Syntax
(no) neighbor NEIGHBORADDRESS PRIORITY|POLL
NEIGHBORADDRESS=A.B.C.D Specifies the interface IP address of the neighbor.
PRIORITY= priority <0-255> (POLL) Specifies the 8-bit number indicating the router priority value of the
non-broadcast neighbor associated with the IP address specified. The default is 0. This keyword does not
apply to point-to-multipoint interfaces.
POLL= poll-interval <1-65535> Dead neighbor polling interval in seconds. It is recommended to
set this value much higher than the hello interval. The default is 120 seconds.
Command Mode
Router mode
Usage
Configure a router as a broadcast network at the OSPF level. To do this, use the neighbor command and include one neighbor
entry for each known nonbroadcast network neighbor. Configure the neighbor address on the primary address of the interface.
Poll interval is the reduced rate at which routers continue to send hello packets, when a neighboring router has become inactive.
Set the poll interval to be much larger than hello interval (RFC 1247).
Examples
This example shows neighbor configured with a priority value and poll interval time.
ospfd# configure terminal
ospfd(config)# router ospf 100
ospfd(config-router)# neighbor 1.2.3.4 priority 1 poll-interval 90
Related Commands
network area
Use the network area command to define the interfaces on which OSPF runs and to define the area ID for those interfaces.
Use the no form of this command to disable OSPF routing for interfaces defined with the address wildcard-mask pair.
Command Syntax
network AREAADDRESS/M area AREAID
no network
AREAADDRESS=A.B.C.D Specifies the network prefix covered by AREAID.
M Specifies the IP-address-type mask that includes "don't care" bits.
AREAID= A.B.C.D.|<0-4294967295> Specifies the area that is to be associated with the OSPF address
range. The area ID can be either a decimal value or an IP address.
Default
Disabled.