Filter
Top Products
Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 161
GARBAGETIMER=<0-4294967295> Specifies the routing garbage collection timer in seconds. The default is 120
seconds.
Command Mode: Router Configuration
Examples
timers 30 180 120
version
Use the version command to set a RIP routing protocol version.
Use the no form of the command to restore the default.
Command Syntax
version <1-2>
no version <1-2>
<1-2> - specifies the version of RIP processing. Default is RIP v2.
Command Mode: Router Configuration
Examples
version 1
Usage
ripd# sh run...
router rip
network 10.10.10.0/24
network 10.10.11.0/24
ripd(config-router)# version 1
router rip...
version 1
network 10.10.10.0/24
network 10.10.11.0/24
OSPF COMMAND REFERENCE
area authentication
Use the area authentication command to enable authentication for an OSPF area. Use the no parameter to remove the
authentication specification for an area.
Command Syntax
area AREAID authentication
no area AREAID authentication
AREAID= A.B.C.D|<0-4294967295>
A.B.C.D= The IPv4 specification of the area for which to enable authentication.
<0-4294967295>= The area identification number of the area for which to enable authentication.
Default
Type 0 authentication or no authentication.
Command Mode: Router mode
Usage
Specifying the area authentication sets the authentication to Type 1 authentication or the Simple Password authentication (details
in RFC 2328). Setting up a Type 1 authentication configures a 64-bit field for that particular network. All packets sent on this
network must have this configured value in their OSPF header. This allows only routers that have the same passwords to join the
routing domain. Give all routers that are to communicate with each other through OSPF the same authentication password.
Use the ip ospf authentication-key command to specify an OSPF authentication password.
Examples
ospfd# configure terminal
ospfd(config)# router ospf 100
ospfd(config-router)# area 1 authentication